seat weaving, slow learning

pfollansbee

Feb 21

seat weaving setup

Sometimes I'm a slow learner. When I made the chair-making video this winter, I wove the bark seat as I sat on a stool - pinned between 2 cameras-on-tripods; and up against the workbench. I flipped the chair up & down in my lap as I wove the top and bottom of the seat. It all worked - but today I did another seat, mostly without a camera and it went swimmingly.

I set a board so it hung off the front of the bench - and sat the chair on that. This time I wove the seat before putting the slats in - that makes winding the first strips (the warp) easier because I didn't have to fish them under the bottom slat. Also easier to flip the chair around without the slats. I'm more comfortable working while standing for the most part, so this was an improvement in that regard as well.

pulling the long strips through the warp

In the "I thought you were supposed to be good at this department" I had to twice pull some weaving out because I messed up the pattern. In both cases I didn't see it until I went to weave the next row.

asleep at the wheel

A butterknife helps fish the weaver through the warp when things get tight. Don't use one from the kitchen, get one from a yard sale or somewhere like that. Your family will be glad you did.

it gets tight near the end

This seat, done for now, took 2 strips of bark, each over 30 feet long. There's one joint under the seat. When the strips dry in a day or two, all these strips will shrink in width. I'll then pack them tighter again and weave in some filler strips to finish the seat. I put one of these filler strips in already, on our left here. There will be one at the front, and one or more on the right side. Then I'll make the slats.